Bandwidth Control; Configure Storm Control; Set Ingress Rate Limiting - TRENDnet TEG-30102WS User Manual

TRENDnet User's Guide
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Bandwidth Control

Configure Storm Control

Bridge > Bandwidth Control > Storm Control
This section allows you to configure the DLF (Destination Lookup Failure), broadcast,
and multicast storm settings for each switch port.
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on Bandwidth Control, and click on Storm Control.
3. Review the settings for each port. Click Apply to save the settings.

DLF (Destination Lookup Failure) – Click the drop-down list and select Enabled
to enable DLF storm control.

Broadcast – Click the drop-down list and select Enabled to enable broadcast
storm control.

Multicast – Click the drop-down list and select Enabled to enable multicast
storm control.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"

Threshold – Enter the pps (packets per second) threshold.
Note: Modifying settings in the row marked All, will apply the settings to all
ports.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

Set Ingress Rate Limiting

Bridge > Bandwidth Control > Ingress Rate Limiting
This section allows you to set the ingress (receive) rate for each switch port.
1. Log into your switch management page (see
on page 11).
2. Click on Bridge, click on Bandwidth Control, and click on Ingress Rate Limiting.
3. Review the settings for each port. Click Apply to save the settings.

Bandwidth – Enter the ingress rate limit value.

Status – Click the drop-down list and select Enabled to enable ingress rate
limiting or select Disabled to disable ingress rate limiting.
Note: Modifying settings in the row marked All, will apply the settings to all
ports.
TEG-30102WS
"Access your switch management page"
44