View And Setup Your Switch Logging - TRENDnet TEG-30102WS User Manual

TRENDnet User's Guide

View and setup your switch logging

System > System Log Settings
The system log is designed to monitor the operation the switch by recording the event
messages it generates during normal operation. These events may provide vital
information about system activity that can help in the identification and solutions of
system problems.
1. Log into your switch management page (see
on page 11).
2. Click on System, and click on System Log Settings.
3. Review the settings. Click Apply to save changes.

Time Stamp
o
Enable - Each event message recorded in the log will have a time
stamp.
o
Disable - No time stamp will be included with the event messages.

Message Buffered Size - Enter the message buffer size. (Range: 1-200)

Syslog - Allows you to send device logging to an external log (Syslog) server for
troubleshooting or monitoring.
o
Syslog Status –

Enable – Enable syslog and in the Syslog Server IP section,
enter the IPv4 or IPv6 address of the external syslog server to
send logging.

Disable – Disable syslog functionality.
o
Facility - Click the drop-down list and which facility to store the
logging. (Options: local0 – local7)
Note: You can define the facility to store logging on your external
syslog server. This helps to ensure you have separate logging sections
for different devices.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
o
Logging Level – Click the drop-down list to select what level of event
messages that will be logged.

0 Emergency - The system is unusable.

1 Alert - Action must be taken immediately.

2 Critical - Critical conditions are displayed.

3 Error - Error conditions are displayed.

4 Warning - Warning conditions are displayed.

5 Notice - Normal but significant conditions are displayed.

6 Informational - Informational messages are displayed

7 Debug - Debug-level messages are displayed.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TEG-30102WS
24