Mounting The Side Cover - American Standard Advanced Clean 100 SpaLet Installation Manual

9

Mounting the Side Cover

1. Attach the side covers on both sides.
[See Note 9-1], [See Reference 9-1],
[See Reference 9-2]
① Insert the "clip" on the upper side of the side
cover into the "clip holder" on the SpaLet bowl
② Align the lines of the SpaLet bowl and the side
cover, and attach the side cover to the "Velcro
fastener" on the lower side of the SpaLet bowl.
Clip
①
②
Side cover
Velcro fastener
[Note 9-1]
● D o not force the side cover to the SpaLet bowl.
* The cover may be damaged.
[Reference 9-1]
● If the water shutoff valve is located on the right when facing the
SpaLet, remove the attached panel attached to the right side cover
and attach it to the left side cover.
① Remove the screw on the back of the right side cover.
② Remove the attached panel from the right side cover.
*Remove in the direction indicated.
③ Attach the attached panel to the left side cover.
*Insert in the direction indicated.
④ Insert the screw on the back of the left side cover to fasten the attached panel.
[Reference 9-2]
● Align the side covers to the SpaLet bowl lines when installing the side covers.
Clip holder
Clip holder
Clip
③ Push the center of the side cover to secure the
"Velcro fastener" firmly.
Velcro fastener
Side cover
(L)
-14 EN-
Side cover
④
③ ②
Align the lines
Side cover
(R)
Attached
panel
Screw
①