American Standard Advanced Clean 100 SpaLet Installation Manual page 10

5
Connecting the Water Supply Hose <Water Shutoff Valve End>
Installation diagram
<Wall water supply>
Clip (white)
Water shutoff valve
1. Install the water supply hose to the
water supply inlet.
① Remove the protective cap.
② Connect the water supply hose.
[See Note 5-2]
Water shutoff valve
Protective cap
③ Affix the clip in the same way as with the
seat unit water supply inlet.
[See Note 4-2], [See Note 4-3],
[See Note 4-1]
• After affixing, rotate the clip, and check
that it is attached properly.
• Also, pull the water supply hose gently to
ensure that it is connected properly.
Clip (white)
Clip (white)
Water
supply hose
Water supply inlet
O-ring
②
Water
①
supply hose
O-ring
Water
shutoff valve
Clip (white)
Water
Water
shutoff
supply hose
valve
[Note 5-1]
● Be careful not to impact the power plug, or
let it fall into the SpaLet bowl.
[Note 5-2]
● Ensure that the water supply
hose is not bent tightly or
stretched.
Do not use a hose that has
been bent.
* The hose may be damaged
resulting in water leakage.
* This may result in incomplete cleaning.
-10 EN-
<Floor water supply>
[See Note 5-1]