Nakayama MB1800 Owner's Manual page 13

2
2.5 mm for cable lengths over 25 m
Before starting up
Intend use
This appliance is only intended as an electric tiller for aerating lawns and grassy areas
in private domestic and hobby gardens.
It is not designed for use in public areas, parks, sports areas, and in agriculture and forestry.
Using the appliance for any other purpose is considered incorrect and unapproved. The
manufacturer is not liable for any damage or injury resulting from such use. The user is
entirely responsible for any associated risks.
Double insulation
The appliance has double insulation. This means that all external metal parts are insulated
from the electrical supply.
This is achieved by introducing an insulation layer between electrical and mechanical parts.
The double insulation guarantees you the greatest possible safety.
Overload protection
The appliance is equipped with a mechanical overload protection sytem. In case the
appliance is blocked by a foreign object, the connection of the motor with the tine shaft will be
cut off automatically.

Swith off the motor,

Remove the blockage. Replace tines if necessary before re-start.
Assemble
Attaching the bar (Fig 2)
Mount the connection bar
swing nuts(a).
Attach the handle bar (2) to the connection bar (4) and fix it by two supplied screws and swing
nuts(a).
Tighten all screws and nuts completely.
Using supplied two cable clips(b)to hold cable in order.
Slide the cable relief(3) on the connecting bar（4）.
Starting
Connection the mains
Secure extension line with cable relief
The loop of the mains wire must be long enough for the cable relief to be able to slide from
one side to the other.
Starting up (Fig. 4)

Press the safety lock button (c) and then pull the trigger level (d) against the bar. The
motor will start and the tines will begin to rotate.

Keep the switch level hold while release the safety lock button.

To stop the appliance, release the trigger level and it automatically returns to its start
position.
Use the tiller for breaking sod, preparing seedbeds, and for cultivating gardens and flower
beds. The tiller can also dig small holes for planting saplings or potted plants.
Tips

Move the appliance to the work area prior to starting the motor.

Hold the appliance firmly, push the rear skid into the ground and raise the appliance and
switch on the motor at no load.

The rear wheels may be used to steady the machine in work but should never be used
as a depth control.

Press down on the handles untill the appliance has dug to the depth required and then
(4) to bar lower section
(Fig. 3)
(3) and connet the mains plug of the appliance.
www.NakayamaTools.com
(5) and fix it by two supplied screws and