Table of Contents
Advertisement
5.3.10 Configuring QoS Settings
Purpose:
QoS (Quality of Service) can help solve the network delay and network congestion by
configuring the priority of data sending.
Steps:
1. Enter the QoS Settings interface: Configuration > Network > Advanced
Settings > QoS
2. Configure the QoS settings, including Video/Audio DSCP, Event/Alarm DSCP and
Management DSCP.
The valid value range of the DSCP is 0 to 63. The bigger the DSCP value is, the
higher the priority is.
Note:
DSCP refers to the Differentiated Service Code Point. The DSCP value is
used in the IP header to indicate the priority of the data.
3. Click Save to save the settings.
Note:
A reboot is required for the settings to take effect.
5.3.11 Configuring 802.1X Settings
Purpose:
The IEEE 802.1X standard is supported by the network cameras, and when the
feature is enabled, the camera data is secured and user authentication is needed
when connecting the camera to the network protected by the IEEE 802.1X.
Note:
802.1X settings vary according to the camera model.
User Manual of Network Fisheye Camera
Figure 5-35 QoS Settings
67
Advertisement
Table of Contents
