Table of Contents
Advertisement
(8) Click Save to save the settings.
5.6.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
alarm response action.
Note:
Video Tampering Detection is not supported when the decoding mode is
hardware decoding and the display mode is 180 Panorama View or 4PTZ.
Steps:
1. Enter the Tamper-proof Settings interface:
Configuration > Event > Basic Event > Video Tampering
2. Check the checkbox of Enable Video Tampering to enable video tampering
detection function.
Figure 5-49 Video Tampering Detection Settings
3. Draw the detection area as in the normal configuration mode.
User Manual of Network Fisheye Camera
88
Advertisement
Table of Contents
