Table of Contents
Advertisement
5. Click-and-drag the line, and you can locate it on the live video as desired.
Click on the line, two red squares are displayed on each end, and you can
click-and-drag one of the red squares to define the shape and length of the line.
6. Select the direction for line crossing detection. And you can select the directions
as A<->B, A ->B, and B->A.
A<->B: Only the arrow on the B side shows; when an object going across the
plane with both direction can be detected and alarms are triggered.
A->B: Only the object crossing the configured line from the A side to the B side
can be detected.
B->A: Only the object crossing the configured line from the B side to the A side
can be detected.
7. Click-and-drag the slider to set the detection sensitivity.
Sensitivity: Range [1 to 100]. The higher the value is, the more easily the line
crossing action can be detected.
8. You can click the Clear button to clear the pre-defined line.
9. Repeat the above steps to configure other lines. Up to 4 lines can be set. You can
click the Clear button to clear all pre-defined lines.
10. Set the arming schedule. Refer to Task 2: Set Arming Schedule for Motion
Detection in Section 5.6.1.
11. Set the linkage method. Refer to Task 3: Set Linkage Method for Motion
Detection in Section 5.6.1.
12. Click Save to save the settings.
5.6.7 Configuring Intrusion Detection
Purpose:
Intrusion detection function detects people, vehicle or other objects which enter and
loiter in a pre-defined virtual region, and some certain actions can be taken when the
alarm is triggered.
Note:
Intrusion Detection is not supported when the decoding mode is hardware
User Manual of Network Fisheye Camera
93
Advertisement
Table of Contents
