Advertisement
substances.
4. The driver does not require lubrication and should not be
lubricated.
■ Pre-operating Preparations
1. Check that the proper Power Pack is being used with the
driver.
2. Connect the Power Pack to plug AC100 to 240 V .
3. Turn the power switch on, check to see that the power
switch light of the Power Pack goes on, then switch the
power off. If the light didn't go on, replace the fuse with the
spare provided with the pack, referring to the Power Pack
specifications.
4. If you want to use as "Push start", follow the instructions
"5" below.
5. To operate in Push-to-start Mode.
BL-3000
Use tweezers to switch lever start/
push start.
BL-5000
Rotate
1
detach
set the start switch to the "PUSH"
position.
Use it without attaching the hex
head screw and the switch lever.
BL-7000
Rotate the hex head screw to detach
the switch lever (Fig-1) and reattach
the switch lever upsidedown. (Fig-2)
Fig-1
To convert the starting mechanism from lever-start to push-to-start,
remove the hex head screw and switch lever, turn the switch lever
upside-down and use the hex head screw to re-fasten the switch
lever.
6. Connect the driver power cord to the Power Pack. (Both
ends of this cord have the same type of connector. Be sure
that the interlocking guide fits together properly and tighten
the joint ring.)
the hex head screw to
2
the switch lever and
Hex head
screw
- 6 -
1
2
Fig-2
LEVER
PUSH
Hex head
screw
Advertisement
