Advertisement
■ Operations
Pre-operating preparation
1. Connect the power cord plug to AC outlet.
2. Turn the power switch to "I", and check if the LED light
is lit.
If the LED light is not lit, inquiry to the distributor. After
confirming that the LED light is lit, set the power switch
to "0", OFF.
3. Connect the driver cord to the power source.
4. How to change to "Push" start.
Unscrew the "Switch lever shaft screw" and then take off
the "Switch Lever". Using sharp parts, such as tweezers,
move the selection SW to "P" (push) near "L ←→P" mark.
Note: Do not press or hit the SW,
otherwise you may damage
the SW or body case.
l Operating procedure
1. Attach a bit to the driver.
2. Turn on the power switch and set the power output
setting to "1" or "2".
Output display setting of each power supply
• T-30BL
• T-70BL
3. Set the FOR/REV switch of the driver to "FOR" (forward
rotation).
4. Set the tightening torque of the driver by torque adjust-
ment nut.
5. Start the driver.
• After placing the bit end on the screw head, press the
switch lever. The driver will start and the screw will be
tightened on the component.
6. When the screw is tightened with the torque value set
to the driver, the clutch works and the rotation stops
immediately.
7. To loosen the tightened screw, set the FOR/REV
switch to "REV" (reverse rotation). The screw will be
loosened after a few impacts.
POWER OF
HIOS
2: (30V), 1: (20V)
2: (30V), 1: (20V)
- 5 -
Switch lever
shaft screw
Switch Lever
"L←→P" select
switch is at the
side of this section.
Advertisement
