Mounting The Telephony Gateway - Arris Touchstone TG862G User Manual

Getting
Safety Started
Step 1
Step 3
Battery
Installation Installation

Mounting the Telephony Gateway

You can either mount the Telephony Gateway on a wall or place it on a desktop.
For wall-mount applications, you can mount the Telephony Gateway with the indi-
cators facing upward (vertical) or to the side (horizontal).
Tools and Materials
For wall-mounted installations, make sure you have the following tools and mate-
Step 2
rials before proceeding:
•
•
•
•
Step 4
•
Location
Always position the Telephony Gateway:
•
•
Instructions
Wall-mounting instructions
Note:
Touchstone TG862 Telephony Gateway User's Guide
Ethernet
Configuration Usage
for mounting on drywall: Two 1/4" (6mm) drywall anchors (not included),
two #6 x 1.5" (38.1 mm) self-tapping panhead screws (not included), and
a drill with 1/4" (6mm) bit (not included)
for mounting on plywood or studs: two #6 x 1.5" (38.1 mm) self-tapping
panhead wood screws (not included)
screwdriver (flat-blade or Phillips, depending on what kind of screws you
use)
wall-mount template (included)
transparent tape: for temporarily securing the mounting template to the wall
(not included)
within reach of an AC outlet. The power cord must reach the outlet without
stretching and without adding extension cords.
near a cable outlet (to avoid long cable runs).
When mounting the Telephony Gateway on drywall, try to position the
Telephony Gateway so at least one of the screws is fastened to a stud.
This may prevent the Telephony Gateway from pulling out of the wall in
the future. To prevent overheating of the Telephony Gateway, do not
block the ventilation holes on the sides of the unit.
Troubleshooting Glossary
22