Table of Contents
Advertisement
G
5. Connecting a gate motorisation system
Use a cable cross-section of 22 mm
IMPORTANT: for the information
feedback to be properly managed,
the position contact (ref. CP500 on
the price list) must be wired before
power-up and be in closed position
when the radio link is established
between the handset and the
controller. If no contact is
connected, the handset display will
show the gate is closed whatever
its status.
The position contact feeds back
the gate status to the screen:
-
gate closed (contact closed),
-
gate open (contact open).
236
2
(telephone type wire) to connect the system.
9 10 11 12 13 14
C
NC NO
NC
Gate motorisation control, 48 V DC/1 A
dry contact relay output.
The motorisation system requires an
external power supply.
If a push-button allowing manual
control of the automatic system has
already been installed, connect
terminal blocks 12 and 14 in parallel
on this manual control input.
3.5
Advertisement
Table of Contents
