Charging The Handset Before Installation - hager SC901AX Manual

4.2 Charging the handset before installation

IMPORTANT: when installing the system, the handset(s) must be charged on the base before it/they can be
used.
4.2.1 Handset on mains-powered base
1. Open the base.

Œ
3. Rotate the back of the base until it is in "table" position.
4. Thread the power pack jack through the
hole.
IMPORTANT: the MHU01X power pack supplied
must be used.
2. Remove the 4 anti-slip pads.
5. Connect the jack to the base making sure
that the cable is positioned in the
designated slot.
Thread the cable
through here
G
Alternative cable
passage
223