Installing The Outdoor System; Installing The Outdoor Caller Unit - hager SC901AX Manual

G

5. Installing the outdoor system

5.1 Installing the outdoor caller unit

IMPORTANT: to ensure the outdoor caller unit remains watertight, never try to open it!
1. To ensure easy use, fix the unit at a height
of 1.20 m.
Please refer to the next chapter for mounting outdoor caller units with armoured cover.
3. If the cable goes around the pillar, pierce
one of the cable knock-outs with a cutter.
5. Thread the cable through the
hole knocked out in step 3
and screw the caller unit
in place. Put the
screw covers back.
Pozidriv 2
228
1.20 m
Follow steps 3 to 6 below for units without armoured cover.
2. Mark and drill the outdoor caller unit holes
with a Ø 6 mm drill bit.
Also mark the place where the cable feed
hole has to be drilled (Ø 8 mm min.
recommended).
4. Push the screw covers out using a flat
screwdriver.
3.5
6. Use a pencil or
permanent marker
to write the names.
Stick a transparent
protection label on
top.
TIP: you can print the
labels using the
software (EtikPrint)
available on the Daitem
web site.