Testing Operation; Testing Communication With Each Interior Handset Unit - hager SC901AX Manual

8. Testing operation

8.1 Testing communication with each interior handset unit

1. Press on the outdoor caller unit call button.
To confirm the call, the outdoor caller unit
rings at regular intervals for 30 sec.
2. The handset rings (1) (except if it is in silent
mode), and the backlighting flashes.
3. If the handset is on its base, pick it up:
- if the automatic pick-up mode is activated,
communication is established,
- otherwise, press the
2. If the handset is already off the base,
press .
4. Open the flip cover to talk and adjust the
audio communication volume using the
keys.
5. At the end of communication, press
and/or put the handset back on the base
to hang up (the handset issues 3 beeps
if it is correctly placed on the base).
If no button is pressed, the communication
is automatically cut off after 3 minutes.
Perform the same test for all of the handsets
(1) If there is no answer, the handset rings for 20 sec. (factory setting) then stops. The duration of ringing can be adjusted
(see Programming handset operating options). If the handset is on the base, it rings at the programmed volume (see
Modifying handset operating options). If the handset is off the base, ringing gradually becomes louder (from level 1 to
the programmed volume).
(2) Access point names can be customised (see Modifying doorphone operating options).
key.
.
IMPORTANT
If the handset being called is
already:
• communicating with another
outdoor caller unit or handset,
• outside the radio range, the
outdoor caller unit sounds
engaged.
The name of the access
point calling (2) is displayed.
C
C
volume +
volume –
C
G
249