OSEE LCM170-E Series User Manual page 54

Menu Operations
Signal Source for
Main Picture
\ Signal Source for
Slave Picture
LINE2(YPBPR)
HDMI
 Position for signal source menu: The input signal information of the main
picture displays at the top left corner of the screen, and the one of the slave
picture displays at the top right corner of the screen.
 Settings for signal source: Press INPUT button to set the signal source for
the main picture, and select CONFIGSUB IN TYPE item to set the signal
source for the slave picture.
H FLIP MODE
The input signal has been inverted horizontally by a mirror type in H FLIP Display
mode.
Select the menu item CONFIG H FLIP to be set to ON, or enable H FLIP in its
coalesced Function Key in Function Key menu, thus to inverse the images
horizontally.
The display result in the Horizontal FLIP MODE is as shown in Figure 4.1-31:

H FLIP mode does not effect on Waveform/Vector, that is, the Wave Form of the
input signal in H FLIP mode will not be inversed horizontally.
AUTO STANDBY
The Auto Standby mode is used to set the status of the monitor when the Power
button is turned on or off.
 ON: set AUTO STANDBY item as ON to enable the auto standby mode. Thus,
SDI1 SDI2 LINE1(CVBS) LINE2(CVBS) LINE2(Y/C) LINE2(YPSPR) HDMI
  
  
Figure 4.1-31 Horizontal Flip Mode


 
48



