Table of Contents
Advertisement
4) Aligning center lines of template and
fuse. Tape the template to the bottom of
the fuse with the back edge of the tem-
plate flush against the aft edge of the re-
cessed cowl mounting ring.
5) Using a hobby knife roughly cut a hole
for the muffler exhaust stacks to pass
through.
Note: This will allow you to pull the tem-
plate up next the engine cylinder head.
6) Trace around the head of the engine
being careful to keep the template in the
same location.
7) Use a hobby knife to cut out the hot air
exit opening as shown.
8) Check the fit of the template at this
time. It may be necessary to make small
adjustments to the cutout to get it to fit
properly.
23
Advertisement
Table of Contents
