Hardware Specification - Contec DIO-1616T-PE User Manual

6. About Hardware

Hardware specification

DIO-1616T-PE
Table 6.1. Specification < DIO-1616T-PE >
Item
Input
Input format
Number of input signal channels
Input resistance
Interrupt
Response time
Output
Output format
Number of output signal channels 16ch (1 common)
Output Output voltage
rating
Output current
Response time
Common
External supply capable current
(Max.)
Allowable distance of signal
extension
I/O address
Interruption level
Max. board count for connection
Power consumption (Max.)
Operating condition
Bus specification
Dimension (mm)
Connector
Weight
*1 Data "0" and "1" correspond to the High and Low levels, respectively.
Board Dimensions
121.69(L)
56
Unisolated TTL level input (Negative logic *1)
16ch (all available for interrupts) (1 common)
10k Ω (1 TTL level load)
16 interrupt input signals are arranged into a single output
of interrupt signal INTA.
An interrupt is generated at the rising edge
(HIGH-to-LOW transition) or falling edge (LOW-to-HIGH transition).
Within 200nsec
Unisolated open-collector output (Negative logic *1)
30VDC (Max.)
40mA (par channel) (Max.)
Within 200nsec (change by pull-up resistor value)
5VDC 350mA
Approx. 1.5m (depending on wiring environment)
Any 32-byte boundary
1 level use
16 boards including the master board
3.3VDC 400mA
0 - 50 ° C, 10 - 90%RH (No condensation)
PCI Express Base Specification Rev. 1.0a x1
121.69(L) x 110.18(H)
37-Pin D-SUB connector [F(female)type]
DCLC-J37SAF-20L9 [mfd by JAE] or equivalent to it
80g
The standard outside dimension (L) is
the distance from the end of the board to
the outer surface of the slot cover.
[mm]
Specification
DIO-1616T-PE, DI-32T-PE, DO-32T-PE