Table of Contents
Advertisement
6. About Hardware
This chapter provides hardware specifications and hardware-related supplementary information.
For detailed technical information
For further detailed technical information ("Technical Reference" including the information such as an
I/O map, configuration register, etc.), visit the Contec's web site (http://www.contec.com/support/) to
call for it.
Hardware specification
The following tables list the hardware specifications of the board.
Table 6.1. Specification
Item
GPIB
Number of channel
Transfer format
Transfer rate
Data buffer size
Signal logic
Cable length between device
Total cable length
Connectable number of device 15 devices
Analyzer buffer size
Bus master section
DMA channels
Transfer bus width
Transfer data length
Transfer rate
Scatter/Gather function
Common section
I/O address
Interrupt
Consumed current (Max.)
Operating conditions
Bus specification
External dimensions (mm)
Connector used
Weight
*1
For details, see item (2) in Chapter3, "Connecting Cables".
GPIB-F-LPE, GPIB-FL-LPE
GPIB-F-LPE
1 channel
Conforms to IEEE-488.1, 488.2(GPIB)
standards
8-bit parallel, 3-wire handshake system
1.5Mbyte/sec
2Kbyte send, 2Kbyte receive
Negative logic L level : 0.8V or less,
H level : 2.0V or more
4m or less *1
20m or less
64K data points
(1 data point : Control signals +
DIO1 - 8)
2 channels
32-bit
8 PCI Words length (Max.)
80Mbyte/sec
64Mbyte/ch
Any 128-byte boundary
1 level use
3.3VDC 600mA
0 - 50°C, 10 - 90%RH (No condensation)
PCI Express Base Specification Rev.
1.0a x1
121.69(L) x 67.90(H)
Micro ribbon connector (24-pin)
5555139-1 [made by AMP] or equivalent
80g
6. About Hardware
GPIB-FL-LPE
None
53
Advertisement
Table of Contents
