Table of Contents
Advertisement
6. About Hardware
This chapter provides hardware specifications and hardware-related supplementary information.
For detailed technical information
For further detailed technical information ("Technical Reference" including the information such as an
I/O map, configuration register, etc.), visit the Contec's web site (http://www.contec.com/support/) to
call for it.
Hardware specification
Table 6.1. Specification
Item
I/O
I/O format
Number of I/O channels
Interrupt
Response time
Rated output current
Common
I/O address
Power consumption (Max.) 3.3VDC 300mA
Operating condition
Allowable distance of
signal extension
Bus specification
Dimension (mm)
Connector
Weight
*1
Data "0" and "1" correspond to the High and Low levels, respectively.
Board Dimensions
121.69(L)
[mm]
DIO-96D-LPE
Unisolated LVTTL-level I/O (Positive logic)
96 channels (all available for interrupts)
96 interrupt input signals are arranged into a single output of interrupt signal INT.
An interrupt is generated at the falling edge (HIGH-to-LOW transition) or
rising edge (LOW-to-HIGH transition).
200nsec within
I
=8mA(Max.) I
=-8mA(Max.)
OL
OH
Any 32-byte boundary (Common to I/O part)
0 - 50 ° C, 10 - 90%RH (No condensation)
Approx. 1.5m (depending on wiring environment)
PCI Express Base Specification Rev. 1.0a x1
121.69(L) x 67.90(H)
68 pin 0.8mm pitch connector
HDRA-E68W1LFDT+ [mfd. by HONDA TSUSHIN KOGYO CO., LTD.] or equivalent
to it
60g
The standard outside dimension (L) is
the distance from the end of the board to
the outer surface of the slot cover.
Specification
6. About Hardware
57
Advertisement
Table of Contents
