Thermostat; Ignition Control - L.B. White CP155 Owner's Manual And Instructions

THERMOSTAT

1. Open the clip holding the thermostat bulb to the fan
guard, and remove fan guard from heater.
FIG. 16
2. Remove knob and thermostat mounting screws. See
Fig. 17.
FIG. 17
SCREWS

IGNITION CONTROL

1. Remove the screws and nuts securing the control to
the front base panel of the heater.
2. When replacing, do not touch or allow contact to the
control's components, otherwise damage may occur.
15 14
3. Unlock the bushing at the thermostat bulb's access
hole at the barrel bottom. See Fig. 18. Guide the
bulb down through the hole. Handle the replacement
thermostat carefully to prevent damage to the
capillary and bulb.
FIG. 18
BUSHING
FIG. 19
NUTS AND
SCREWS