Thermostat Installation - L.B. White AB230 Owner's Manual And Instructions

THERMOSTAT INSTALLATION

Electrical Shock Hazard
Disconnect the electrical supply before connecting the
thermostat to the heater.
Failure to follow this warning can result in electrical
shock, leading to personal injury or death.
1. To Connect the Series Tap Plug Thermostat Kit:
a. Connect the power cord of the heater to the
female side of the plug on the end of the
thermostat cord.
b. Plug the male side of the series tap plug on the
thermostat cord into a three-wire (grounded)
electrical outlet within the building.
10
WARNING
2. To Connect the Direct Wired Thermostat Kit to the
Control Box on the Heater:
a. The installation and wiring of a thermostat must
be done by an electrician or someone properly
qualified.
b. The thermostat may use 18 gauge, 3 wire cord to
handle the voltage being supplied to the
thermostat.
c. Follow all instructions provided with the
thermostat kit.
d. The heater must be tested for proper operation
after the thermostat has been connected.