Table of Contents
Advertisement
True Food Service Equipment, Inc.
INSTALLATION THROUGH 34 INCH DOOR OPENINGS
TOOLS REQUIRED:
A. Gloves
B. Utility Knife
C. Phillips Screw Driver or Cordless
Drill with Phillips Bit
D. ¾" Socket
E. (2) Four Wheel Dolly
NOTE: Remove all the packing
material from the cabinet. Be sure
to save all the packing material to
use when tipping the cabinet on its
side.
STEP 1
Locate the wire harness coming out
of the back of the digital display/
energy saving switch and remove the
male molex plug from the control box
located on the right hand side of the
condensing unit. (See image 1).
Image 1
5
INSTALLATION / OPERATION INSTRUCTIONS
Open the doors, locate and remove the
Phillips screws on the underside of the
rain shield. (See images 2-3)
Image 2
Image 3
Locate and remove the screws on top
of the rain shield. You can now remove
the rain shield. Be sure to lay it down
on a flat surface to prevent the rain
shield from falling over and being
damaged. (See image 4)
Image 4
............ www.truemfg.com ............
STEP 2
STEP 3
STEP 4
Remove both doors. To do this, open
the door 90º and lift up on the door.
Be sure to place the door upright on
a secure surface to prevent the doors
from falling over and being damaged.
(See image 5).
Image 5
STEP 5
Place a piece of packing material on
the left side of the cabinet. If you're
using a four wheel dolly place this on
the left side of the cabinet. Be sure
that the dolly is padded. If not, place
several pieces of cardboard on it to
protect the dolly from scratching the
left side of the cabinet. (See image 6)
NOTE: Depending on the size of
your dolly you might need to use
more than one.
Image 6
5
Advertisement
Table of Contents
