Table of Contents
Advertisement
True Food Service Equipment, Inc.
ELECTRICAL INSTRUCTIONS
A. Before your new unit is connected to a power supply,
check the incoming voltage with a voltmeter. If
anything less than 100% of the rated voltage for
operation is noted, correct immediately.
B. All units are equipped with a service cord, and must
be powered at proper operating voltage at all times.
Refer to cabinet data plate for this voltage.
TRUE requires that a sole use circuit be dedicated for the
unit. Failure to do so voids warranty.
STARTUP
A. The compressor is ready to operate.
Plug in the cooler.
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 35°F and
freezers an approximate temperature of -10°F. Allow
unit to function several hours, completely cooling
cabinet before changing the control setting.
C. Excessive tampering with the control could lead
to service difficulties. Should it ever become
necessary to replace temperature control, be sure
it is ordered from your TRUE dealer or a
recommended service agent.
D. Good air flow in your TRUE unit is critical. Be
careful to load product so that it neither presses
against the back wall, nor comes within four inches
of the evaporator housing (Interior Top). Refrigerated
air off the coil must circulate down the back wall.
DIGITAL TEMPERATURE DISPLAY
The digital temperature display can view °C or °F. To achieve
this, there is a small plug that will need to be removed to
achieve °C reading. See image 1 for temperature display location.
If the plug is kept in the back of the digital display °F will be
viewable. See images for reference. When temperature display
is in °C mode place the plug in a safe place so it can be easily
reinstalled for °F reading.
11
INSTALLATION / OPERATION INSTRUCTIONS
............ www.truemfg.com ............
WARNING
Compressor warranties are void if compressor burns out due
to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - locate the diagram inside large
junction box on top of unit.
NOTE
If the unit is disconnected or shut off, wait five minutes before
starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE unit
empty for two to three days. This allows you to be sure electrical
wiring and installation are correct and no shipping damage has
occurred. Remember, our factory warranty does not cover product
loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your
cooler. If at any time during the life of your cooler, a part is
needed, you may obtain this part by furnishing the model number
and serial number to the company from whom you purchased
the cooler. Call Toll-Free: (800)-424-TRUE (Direct to Parts
Department). (800)-325-6152 (U.S.A. & Canada only) or call:
(636)-240-2400.
Image 1 (Rear of Rainshield)
°F
Image 2
°C
Image 3
11
Advertisement
Table of Contents
