Table of Contents
Advertisement
Available languages
Available languages
Page EN-10
Care and maintenance
(13)
5. Place the grease filters (15) with the pins
into the openings.
6. Push the locks (14) up; snap the grease
filters (15) in and release the locks.
7. Close the cover (13) again and allow it to
click into place.
8. Switch the power back on.
Inserting/replacing activated
charcoal filters
The activated coal filters remove odours.
They have to be replaced as soon as the
cooking odours can no longer be adequately
filtered. If used frequently, the filters should be
renewed regularly or at least checked every 6
months. For the source of supply, please see
chapter „Our Service Centre" on page EN-21.
1. Unplug the mains plug or switch off the
corresponding circuit.
(13)
(14)
(14)
(15)
(15)
2. Flip the cover (13) up.
3. Open the locks (14) on the grease fil-
ters (15), and carefully pull the grease
filters (15) downwards to remove them.
4. Only when replacing the charcoal filters:
The two activated charcoal filters (17) are
located to the right and left of the motor
(16).
Loosen the two activated charcoal filters
and remove them.
(17)
5. Place the new activated charcoal filters to
the right and left of the motor and tighten
them in an anti-clockwise direction. Allow
the locks to click into place.
(16)
(17)
Advertisement
Chapters
Table of Contents
