Driving Off; Cancelling A Remote Start; Remote-Starter Features; Idle Mode (Automatic Transmission) - Fortin DL1004 User Manual

Automatic / manual transmission-1-way remotes
Hide thumbs Also See for DL1004:
Table of Contents

Advertisement

STEP 5
The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence from step 1.
TO DEACTIVATE READY MODE:
• Open any door(s)
Note : If the parking lights fl ash 3 times when Remote-Starting, Ready Mode is not enabled.

DRIVING OFF

When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the following
steps:
STEP 1
STEP 2

CANCELLING A REMOTE START

See USING THE REMOTE CONTROL, page 4

REMOTE-STARTER FEATURES

IDLE MODE (AUTOMATIC TRANSMISSION)

Idle Mode allows the vehicle to run without the key in the ignition barrel. For example, if you stop for a
quick errand or delivery, simply allow the vehicle to run while you are gone. The engine will run until the
Remote-Starter runtime expires. Press START any time the vehicle is running with the Remote-Starter
to reset this timer. To activate Idle Mode (automatic transmission) proceed with the following steps:
STEP 1
STEP 2
The engine will continue to run until either the remote stop function is pressed (see USING THE RE-
MOTE CONTROL, page 4), the Remote-Starter runtime expires, the parking brake is disengaged,
the brake is pressed, or the hood is opened. If the Remote-Starter is shut down by transmitter it will
automatically go in to Ready Mode (if all the doors are closed).
WARNING : Never leave children or animals in a Remote-Started vehicle unattended.
I DLE MODE (MANUAL TRANSMISSION)
Idle mode is activated in much the same way Ready Mode is activated, except for Step 1. To activate
Idle Mode (manual transmission) proceed with the following steps:
IDLE MODE ACTIVATION:
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are closed.
Open the hood
Insert the key and turn it to the ignition (ON/Run) position.
Warning: Do not turn the key to the START position when the engine is
running. This may damage the ignition system on some vehicles.
Step on the brake pedal to disable the Remote-Starter, and put the vehicle
in gear.
With the key in the barrel at the ignition (ON/RUN) position and the en-
gine running, press the START button until the parking lights turn on.
OFF
Turn the key to the OFF position and remove the key from the ignition
barrel. The vehicle will continue to run with the Remote-Starter.
The vehicle must be running.
Disengage of the parking brake
Page 7 / 14

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ant-fmh-2w

Table of Contents