Driving Off; Cancelling A Remote Start - Fortin RM442 User Manual

METHOD 2 - This method must be programmed by the installer during installation. This method
will activate the remote starter sequence everytime the end user is leaving the vehicle. automatic.
ACTIVATION :
The vehicle must be running.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence
from step 1.
TO DEACTIVATE READY MODE :
•
Open any door(s)
Note : If the parking lights fl ash 3 times when Remote-Starting, Ready Mode is not enabled.

DRIVING OFF

When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the
following steps :
STEP 1
STEP 2

CANCELLING A REMOTE START

See FULL FUNCTIONS, page 6.
Make sure that all doors are closed and that the transmission is in
the NEUTRAL position.
While the engine is running, engage the parking brake.
Release the brake pedal.
Remove the key from the ignition barrel. The engine will shut down
and the vehicle will be ready to start at any time.
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors
are closed.
•
Open the hood
Insert the key and turn it to the ignition (ON / RUN) position.
WARNING : DO NOT TURN THE KEY TO THE START POSITION WHEN
THE ENGINE IS RUNNING. THIS MAY DAMAGE THE IGNITION SYSTEM
ON SOME VEHICLES.
Step on the brake pedal to disable the Remote-Starter, and put the
vehicle in gear.
•
Disengage of the parking brake
Page 11 / 21