Page 1
REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUTOMATIC / MANUAL TRANSMISSION - 1-WAY REMOTES FTX94-1W User Guide Model : FTX94 Model : ANT-FMH-2W FCC ID : 2ACKU-R1W04FM FCC ID : 2ACKU-A2W01FM IC : 12084A-R1W04FM IC : 12084A-A2W01FM...
TABLE DES MATIÈRES TABLE OF CONTENTS TABLE OF CONTENTS ......................... 2 INTRODUCTION ..........................2 CAUTION - WARNING ......................... 3 NOTE ................................3 INDUSTRY CANADA USER NOTICE ...................... 3 GOVERNMENT REGULATIONS ......................3 USING THE REMOTE CONTROL ......................4 REMOTE-STARTING ..........................5 REMOTE-STARTING THE VEHICLE .......................
CAUTION - WARNING IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • ensure that the vehicle is parked in a safe and responsible manner. • ensure that the vehicle is not remotely started indoors (garage, underground parking). •...
USING THE REMOTE CONTROL The remote starter is equipped with two 1-way 4-button multi-channel remote control. TIME COMMAND DESCRIPTION PRESSED Locks all doors, arm the anti-theft system and activates the Alarm (if LOCK 0,5 SEC. installed). Press LOCK for 3 sec- onds to activate the Panic Mode Unlocks all doors, disarms the anti-theft system and deactivates...
REMOTE-STARTING REMOTE-STARTING THE VEHICLE This Remote-Starter supports both manual and automatic transmission vehicles. For manual transmis- sion vehicles see the Ready Mode section. REMOTE-STARTING STEP To remote-start the vehicle press the START button for approximately 3 second. STEP The parking lights will turn on to indicate a response to the Remote-Start signal.
Page 6
METHOD 1 PROGRAMMED BY DEFAULT THIS METHOD WILL ACTIVATE THE REMOTE CAR STARTER SEQUENCE ONLY WHEN THE END USER IS USING THE REMOTE CAR STARTER REMOTE: The vehicle must be running. STEP 1 Make sure that all doors are closed and the transmission is in the NEUTRAL position.
DRIVING OFF When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the following steps: STEP 1 Insert the key and turn it to the ignition (ON/Run) position. Warning: Do not turn the key to the START position when the engine is running.
STEP 5 Press the remote START button. The parking lights will fl ash once and then remain on. STEP 6 Remove the key from the ignition barrel. The vehicle will continue to run with the the Remote-Starter. STEP 7 Exit the vehicle and close all of the doors. The vehicle will continue to run after all the doors are closed.
VALET CODING DISABLED (DEFAULT): To activate and deactivate Valet Mode using the valet switch proceed with the following steps: STEP 1 Insert the key and turn it to the ignition (ON/RUN) position. The vehicle does not need to be started. STEP 2 Within 10 seconds press and release the button on the antenna 3 times.
To disable Cold Start Timer Mode do any of the following: • Press and release the FUNCTION but- • Put the Remote-Starter/ • Turn the key to the ignition ton, within 12 seconds to simultane- alarm into Valet Mode. (ON / RUN) position. •...
REMOTE DOOR LOCKS If the Remote-Starter is installed with door locks, you will be able to lock and unlock the vehicle without using the key or OEM key fob. To UNLOCK the doors and DISARM the Alarm: The parking lights will fl ash twice and the LED will turn OFF to confi rm the signal.
ALARM AUDIBLE CONFIRMATION By default the Alarm will not send an audible confi rmation (horn/siren) after the fi rst signal has been received from the remote transmitter(s). SILENT : Press the LOCK or UNLOCK button ONCE and the park lights will fl ash, but the horn/siren will NOT confi rm the signal.
TRANSMITTER RANGE Several factors may affect the operating range of the remote transmitter: • A weak transmitter battery. • The operating environment such as in the city and airports due to radio interference, cell phone towers, etc… • Several types of metal such as the vehicle itself, other vehicles, the windshields tint lines and large buildings.
REMOTE START / ALARM DIAGNOSTICS REMOTE STARTER DIAGNOSTICS ALARM DIAGNOSTICS Parking Light fl ashes (before starting) : Parking Light fl ashes (after disarm) : Ready mode disabled Door open – zone 3 Valet mode activated (The LED is on) Shock sensor – zone 4 Hood open Hood open –...