Scan - HYT TM-600 VHF Manual

Scan

Radio scans all the channels that have been added into the scan list of the current zone.
▇ Scan Start
① Add one or several non-priority channels into the scan list.
② Press the Channel Scan key (programmable) to initiate scan from the current channel,
then scanning proceeds in ascending order by channel number, while the scan LED lit up.
▇ Scan Cease
Scanning pauses or ceases upon the following:
1. Upon repress the Channel Scan key (programmable), scanning ceases, scan LED
goes out, then radio exit the scan mode.
2. Activate the Monitor function.
3. Carrier is detected on a channel that is not set with signalling.
4. Carrier is detected and match signalling is received on a channel that is set with
signalling.
▇ Scan Resume
If scanning pauses on an active channel, the scanning will resume according to the scan
resume mode. The scan resume mode is programmable by your dealer for Carrier
operated scan or Time operated scan.
1. Time operated scan
Scanning remains on an active channel for a programmed time period (programmable
by your dealer), once the timer expires, the radio will begin scanning other channels
even if the active channel is still busy.
2. Carrier operated scan
If carrier is detected during the scan sequence, scanning will remain on the active
channel until there is no activity.
▇ Dual Priority Scan
If dual priority channels are programmed by your dealer, the radio still checks the dual
priority channels for activity at configured intervals, while scanning pauses on a
non-priority channel. When any activity is detected on a priority channel, the radio will
immediately switch to the active priority channel.
▇ Nuisance Channel Temporary Delete
第 18 页 共 31 页