Table of Contents
Advertisement
Auto mode:
To access the auto mode press "MODE" until the display shows
will now run through its built in programs
press the "MODE" button. NOTE: The user can set up the speed and flash speed for
under the built in programs mode. Changing this here will then take effect when running auto mode.
RGBWAUV colour mix mode:
To access the static colour mode press "MODE" until
Now press the "SETUP" button and use the "UP" and "DOWN" buttons to select the brightness
r. 0 00
r. 2 55
between
~
A
I
amber (
) and UV (
).
Value: 000 - 255 (000 = low brightness, 255 = high brightness)
To exit out of any of the above options, press the "MODE" button.
Factory reset:
To reset the fixture to factory settings, power the fixture off. Press and hold the "MODE" and "SETUP"
buttons whilst powering the unit up. Keep hold of the "MODE" and "SETUP" buttons for 3 seconds after
power up. The unit will now have reset to factory settings.
Menu system
Built-in program
RGBWAUV colour mix
mode
Auto mode
Slave mode
DMX mode
Address setting
www.prolight.co.uk
Pr. 0 2
. Press the "SETUP" button and repeat for green (
Pr. 0 1 Static colour
Pr. 0 2 6 colour fade in/out
Pr. 0 3 Colour fade in/out
Pr. 0 4 Colour fade
Pr. 0 5 6 colour change
Pr. 0 6 Colour change
Pr. 0 7 Red continuous fade
Pr. 0 8 Green continuous fade
Pr. 0 9 Blue continuous fade
Pr. 1 0 White continuous fade
Pr. 1 1 Amber continuous fade
Pr. 1 2 UV continuous fade
SP00~SP99 (speed)
F500~F599 (flash)
r. 0 00~r. 2 55 Red
g. 0 00~g. 2 55 Green
b. 0 00~b. 2 55 Blue
u. 0 00~u. 2 55 White
A. 0 00~A. 2 55 Amber
I. 0 00~I. 2 55 UV
AUTO
SLAu
6CH, 8CH, 10CH
d. 0 01~d. 5 12
Spectra Par 12HEX10 PRO User Manual
Operating instructions
Auto
Pr. 1 2
~
. To exit out of any of the above options,
CoLr
shows on the LED display.
on the LED display. The fixture
Pr. 0 2
Pr. 1 2
~
G
b
), blue (
), white (
u
) ,
6
Advertisement
Table of Contents
