Direct Power Off Function - Panasonic PT-VX615N Operating Instructions Manual

Direct power off function

When the plug is disconnected from the outlet or the power is turned off by the circuit breaker in the ceiling mount
case while the projection is going on, the projector can respond with direct power off function. Therefore, it is also
safe in case a power outage occurs or the power cord is pulled out immediately after the projector is switched off.
Attention
f Do not disconnect the power cord from the wall outlet or turn off the circuit breaker switch in about 1 minute after the lamp is lit. Doing so
may cause the lamp fail to light while you powering on the projector next time, or result in premature deterioration of the luminous lamp.
Note
f If the [PROJECTOR SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY] and the projector was turned off by using the circuit
breaker directly while projecting during the last time of use, the power indicator <ON(G)/STANDBY(R)> will light in green a while after the
circuit breaker is turned on, and then projection of the image will start.
f If the projector is shut down with the direct power off function, it may take longer than usual to be ready for projection when the projector is
switched on the next time.
50 - ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector