Powering Off The Projector; Direct Power Off Function - Panasonic PT-VW340 Series Operating Instructions (Functional Manual)

Powering Off the Projector

1) Press the <v/b> button on the control panel or the <v> button on the remote control.
f The following message appears.
2) Press qw to select [OK], and press the <ENTER> button.
OR
Press the <v/b> button on the control panel or the <v> button on the remote control again.
f Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> lights in orange. (The fan keeps
running.)
3) Wait until the <ON(G)/STANDBY(R)> indicator lights or blinks in red.
f The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights or blinks in red.
Note
f Do not put the projector in a case before the projector is cooled enough.
f While the <ON(G)/STANDBY(R)> indicator is lighting in orange, the lamp is being cooled down and the projector cannot be
turned on. Wait until the <ON(G)/STANDBY(R)> indicator starts lighting or blinking in red to turn on the projector again.

Direct Power Off function

You can disconnect the power cord from the wall outlet or turn off the breaker even during projection.
Note
f When using the Direct Power Off function, you cannot restart the projector immediately after the power is disconnected. The
lamp remains high temperature and needs to be cooled, so it sometimes takes longer time than usual for the lamp to light up
again.
Chapter 3 Basic Operations - Powering on/off
1) 2)
3)
1) 2)
2)
2)
ENGLISH - 43