Table of Contents
Advertisement
3.5
Positioning the displays angled
To position the displays
1. Remove the arm covers.
2. Loosen the allen screws of both the left and right positioning slider.
3. Slide both displays at maximum distance from one another, being careful not to slide a display off the
arm.
4. Rotate the left and right display by pulling the arm in or out from the center shaft, until they make the
required angle. Verify that the cables are still correctly routed and no connection is stressed.
5. Slide both displays to each other, until they are aligned and the brackets are on similar numbers.
6. Fasten the allen screws of both the left and right positioning sliders (minor deficiencies in alignment can
be corrected by adjusting the relative depth of opposite screws).
7. Re-attach the arm covers.
3.6
Mounting the film clip
To mount the film clip
The film clip can be mounted on the top, left or right side of the display.
1. Position the film clip on the bezel at the desired location.
2. Push the clip at the front towards the bezel . The film clip will click in place.
3. Slide the clamp downwards (or sideways) over the screen.
4. To remove the film clip, lift the rear end of the clip out of the side frame.
3.7
Mounting the keyboard light
To mount the keyboard light
1. The text on the white plastic clip indicates the front side of the keyboard light. This side must be mounted
at the front side (image side) of the display.
2. With the enclosed Allen key, loosen both screws at the bottom of the desktop light hinge. Loosen the
screws until the thread start surface of the screws are at the same height as the bolts as shown in the
drawing below.
K5902035 MAMMO TOMOSYNTHESIS 07/12/2017
FRONT
3. Display installation
15
Advertisement
Table of Contents
