Door Panel Installation - golmar Stadio Plus T500ML Instruction Manual

DOOR PANEL INSTALLATION

H
old the door panel on the embedding box.
Select a direction to open the door panel; this selection should ease
the door panel wiring.
The opening direction will be settled through the hinges position,
that must be passed through the header clips as shown.
For example, if the hinges are placed on both clips of the lower
header, the door panel will open downwards; if they are placed
on the right clips of both headers, the door panel will open to left.
To hold the door panel on the embedding box,
insert the hinges in the embedding box lockers
as shown.
Link the sound module with the EL500
microprocessed circuit by using
the supplied flat cable.
79 80
Twist the call wires as shown. The call wires will be
connected to the EL500 microprocessed circuit or
to the corresponding EL516 push buttons encoder.
P
lace the nameplate labels.
DOOR PANEL INSTALLATION
C
ableado de los pulsadores.
For a quality finish, pass the push buttons wires through
the spacer hole of the closest module.
It's recommended to use wires of less than 0,25mm
section.
IMPORTANT: link the push buttons common terminal
of the several push buttons modules.
The common terminal of the push buttons contained
in a module are linked from factory
This wire must be connected to the CP terminal
of the EL500 microprocessed circuit or of the
corresponding EL516 encoder circuit.
Open the label holder.
2
Place the label and
close.