Safety Precautions - Acnodes FES93 Series User Manual

Read these instructions carefully before you install, operate, or transport the system.
 Install the system or DIN rail associated with, at a sturdy location
 Install the power socket outlet near the system where it is easily accessible
 Secure each system module(s) using its retaining screws
 Place power cords and other connection cables away from foot traffic. Do not place items over
power cords and make sure they do not rest against data cables
 Shutdown, disconnect all cables from the system and ground yourself before touching internal
modules
 Ensure that the correct power range is being used before powering the device
 Should a module fail, arrange for a replacement as soon as possible to minimize down-time
 By means of a power cord connected to a socket-outlet with earthing connection
 This product is intended to be supplied by a Listed Power Adapter or DC power source, rated
24Vdc, 16A, Tma 60 degree C and 5000m altitude during operation.
 If the system is not going to be used for a long time, disconnect it from mains
(power socket) to avoid transient over-voltage

Safety Precautions

Hot Surface Warning
HOT SURFACE. DO NOT TOUCH. "ATTENTION: Surface
chaude. Ne pas toucher."
WARNING!
Components/ parts inside the equipment may be hot to
touch! Please wait one-half hour after switching off before
handling parts.
Battery Warning
Batteries are at risk of exploding if incorrectly installed

Do not attempt to recharge, force open, or heat the battery

Replace the battery only with the same or equivalent type

recommended by the manufacturer
6