4.6
Power On after Power Failure
This option defines the system's behavior when DC power is supplied.
Value
S0 – Power On
S5 – Power Off
Last State
When you want to use the AT-mode remote on/off control function, you have to set
this option to "S0 – Power On". Please refer to
Non-Latched Switch
To set "Power On after Power Failure" option:
1.
Press F2 when the system boots up to enter the BIOS setup utility.
2.
Go to [Power].
3.
Set the [Power On after Power Failure] option to the desired setting.
4.
Once set, press F10 to save setting and exit.
Description
System is powered on when DC power is supplied.
System is kept in off state when DC power is supplied.
Last system operating state when DC power loss occurred.
for instructions of using AT-mode remote on/off control function.
70
Powering On Using An External