Table of Contents
Advertisement
If select "SQ",it indicates you can hear the calling from caller when
receive a matching carrier.
If LCD displays "CTC",it indicates
you can hear the calling from caller
when receive a matching carrier and
CTCSS/DCS signaling .
If LCD displays "TON",it indicates
you can hear the calling from caller
when receive a matching carrier and
DTMF/2TONE/5TONE signaling .
If LCD displays "C/T",it indicates you
can hear the calling from caller when
receive a matching carrier and CTCSS/
D C S a n d D T M F / 2 TO N E / 5 TO N E
signaling .
If LCD displays "C/T",it indicates you can hear the calling from
caller when receive a matching carrier and either CTCSS/DCS
DTMF/2TONE/5TONE signaling. .
4.
Press
key to confirm and exit.
This function is available only for pre-programmed units with
Tone-signals and CTCSS/DCS selective calling.
HIGH/MID/LOW Power Selection
1.
Press and hold
key for over 2
seconds to enter setting menu.
2.
Press
/
key to choose No.07
menu, LCD displays"POW--HI".
PARAMETER SETTING MODE
3.
Turn Main Dial to select the desired setting.
TX Power (60W narrow)
4.
Press
key to confirm and exit. This feature is the same as
[FUNC]+[H/L] key operation.
Band-width Selection
Select suitable bandwidth in accordance with your local band-plans.
1.
Press and hold
key for over 2 seconds to enter setting menu.
2.
Press
/
key to choose No.08
menu, LCD displays"BAND--25".
3.
Turn Main Dial to select the desired
setting.
12:band width is 12.5KHz(Narrow band)
4.
Press
key to confirm and exit.
TX OFF SETUP
This function is to prohibit the transmission and to use the radio as a
receiver.
1.
Press and hold
key for over 2 seconds to enter setting menu.
2.
Press
/
key to choose No.09 menu, LCD displays"TX-
ON".
7
18
Advertisement
Table of Contents
