How To Assemble Your Ceiling Fan Blades And Cap - Fanimation LEVON CUSTOM MAD7912BBL Manual

How to Assemble Your Ceiling Fan Blades and Cap

1. Lay the side of the blade holder on a flat surface
with the inside of the blade holder facing up.
Assemble the blade to the blade holder with the
carriage nuts, flat washer, and screws. Make sure
that the blades are fully seated against the blade
holders and tighten screws. (Figure 1)
NOTE: You will find the fan blade set packed in its own
carton and the blade holders and hardware bag in the
fan box.
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Attach assembled blades and blade holders to
the motor hub using the provided screws with lock
washers. Make sure the screws securing the blade
holders to the motor hub are tight and that the blade
holders are properly seated. (Figure 2)
NOTE: Periodically check Blade Holder hardware and re-
secure if necessary. (see Maintenance below)
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
CAUTION
Blade Holder
HARDWARE USED:
3/16 -24
SCREWS
FLAT WASHER
3/16 -24 CARRIAGE
HEAD NUT
HARDWARE USED:
1/4 -20
SCREWS
12
Blade
Figure 1
x 24
x 24
x 24
Screw
(2 per blade
holder)
Figure 2
x 8