How To Assemble Your Ceiling Fan Blades And Cap - Fanimation WRAP MAD8530 Manual

How to Assemble Your Ceiling Fan Blades and Cap

1A. MAD8530**
Remove and discard the three rubber/screws
motor stops from the motor assembly. (Figure 1a)
1B. MAD8531**
Remove and discard the six rubber/screws
motor stops from the motor assembly. (Figure 1b)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
2. Position blade along the motor, aligning blade
holes with holes in the top of the motor assembly
flywheel. Make sure the blade is fully seated against
the flywheel and install serrated head screwswith
stainless flat washers from the hardware bag, but
don't fully tighten at this time. (Figure 2)
NOTE: You will find the fan blade set packed in its own
carton and hardware bag in the fan box.
3. Install and securely tighten all screws with stain-
less flat washers at the underside of the blades , then
securely tighten all previously installed screws on top
of motor. (Figure 3)
NOTE: You will find plastic cap in fan blade set carton.
To avoid injury to your hand, please be careful when
installing the plastic plate to the magnet on the motor
assembly as the strength of the magnet will quickly
attract the cap, causing it to snap down, possibly
pinching or crushing your hand.
WARNING
Figure 1a
HARDWARE USED:
3/16 -24
SERRATED HEAD
SCREWS
STAINLESS
FLAT WASHER
12
Figure 1b
Blade
Figure 2
Blade
Figure 3
x 18
x 18
Figure 4