How To Assemble Your Ceiling Fan Blades And Cap - Fanimation LEVON MAD7912B Series Manual

How to Assemble Your Ceiling Fan Blades and Cap

1. Remove and discard the four rubber/screws motor
stops from the motor assembly. (Figure 1)
2.
Lay the side of the blade holder on a flat surface
with the inside of the blade holder facing up. Assemble
the blade to the blade holder with the carriage nuts,
flat washers and screws. Make sure that the blades
are fully seated against the blade holders. Tighten
screws with screwdriver, don't over-tighten. (Figure 2)
NOTE: You will find the fan blade set packed in its
own carton and the blade holders and hardware bag in
the fan box.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
3. Attach assembled blades and blade holders to the
motor hub using the provided screws with lock
washers from the hardware bag. Make sure the
screws securing the blade holders to the motor hub
are tight and that the blade holders are properly
seated. (Figure 3)
NOTE: Periodically check Blade Holder hardware and
resecure if necessary. (see Maintenance below)
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
Blade
Holder
3/16"-24
Carriage
Head Nut
3/16"-24
Screws
Flat Washers
3/16"-24
Carriage Head Nuts
1/4"-20
Screws
14
Figure 1
3/16"-24
Screw
Flat Washer
Figure 2
HARDWARE USED:
Figure 3
HARDWARE USED:
Motor Stop
Blade
X 24
X 24
X 24
Screw
(2 per
blade
holder)
X 8