Ceiling Fan Assembly - Emerson AMHURST CF880VS Owner's Manual

54” ceiling fan

Hide thumbs

Table Of Contents

Table of Contents

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Tools Needed for Assembly

One Phillips head screwdriver

One stepladder

One wire stripper

Materials

Wiring outlet box and box connectors must be of type

required by the local code. The minimum wire would be

a 3-conductor (2-wire with ground) of following size:

1. Remove the hanger ball by loosening the setscrew in

the hanger ball until the ball falls freely down the

downrod (Figure 1). Remove the pin from the

downrod, then remove the hanger ball. Retain the pin

and hanger ball for reinstallation in Step 6.

2. Loosen the two setscrews in the motor coupler to

prepare for the installation of the downrod (Figure 2).

3. Separate, untwist and unkink the three 80" motor

leads. Route the motor lead wires through the

downrod. Align the clevis pin holes in the downrod

with the holes in the motor coupler. Install the clevis

pin and secure with the hairpin clip (Figure 2). The

clevis pin must go through the holes in the motor

coupler and the holes in the downrod. Be sure to

push the straight leg of the hairpin clip through the

hole near the end of the clevis pin until the curved

portion of the hairpin clip snaps around the clevis pin.

The hairpin clip must be properly installed to prevent

the clevis pin from working loose. Pull on the

downrod to make sure the clevis pin is properly

installed.

4. While pulling up on the downrod, tighten the two

setscrews in the motor coupler (Figure 2).

WARNING

It is critical that the clevis pin in the motor coupler is

properly installed and the setscrews securely

tightened. Failure to verify that the pin and setscrews

are properly installed (as shown in Figure 2) could

result in the fan falling.

Install, Operate and Maintain Your Ceiling Fan