Table of Contents
Advertisement
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
1. Position the supply wires to the left side of the outlet
box (Figure 12); position the fan wires to the right
side. Partially insert the remote control receiver (flat
side up) until one end rests on the hanger ball as
shown in Figure 12.
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except
for the ground wire.
WARNING
!
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
2. Refer to Figure 12 and 13 and connect the receiver
wires to the supply wires and the fan motor wires as
follows:
a. Securely connect the green grounding wires from the
hanger ball and the hanger bracket to the supply
grounding conductor (this may be a bare wire or a
wire with green insulation).
b. Securely connect the supply white (neutral) wire to
the receiver white (AC IN N) wire.
c. Securely connect the supply black wire (hot) wire to
the receiver black (AC IN L) wire.
How to Wire Your Ceiling Fan
SUPPLY WHITE
WIRE (NEUTRAL)
SUPPLY BLACK
WIRE (HOT)
GROUND WIRE
GREEN GROUND WIRE
FROM HANGER BALL
ANTENNA
GREEN GROUND WIRE
FROM HANGER BRACKET
1-1/4" THREADED
STUD (2)
FAN WHITE WIRE
Figure 12
STANDARD ON-OFF WALL
SWITCH OR OPTIONAL
WALL CONTROL
BLACK
(HOT)
TO
120-
VOLT
WHITE
SUPPLY
GROUND
TWO-CONDUCTOR
CABLE (WITH
GROUND)
GREEN WIRE (GROUND)
FROM HANGER BALL
AND HANGER BRACKET
Figure 13
d. Securely connect the fan motor white wire to the
receiver white (TO MOTOR N) wire.
e. Securely connect the fan motor black wire to the
receiver red (TO MOTOR L) wire.
f. Securely connect the fan motor blue wire to the
receiver blue (FOR LIGHT) wire.
Please contact 1-800-654-3545 for further assistance
9
RECEIVER WHITE WIRE
RECEIVER BLACK
WIRE
RECEIVER
RED WIRE
RECEIVER
BLUE WIRE
FAN BLACK
WIRE
FAN BLUE WIRE
RECEIVER WHITE
WIRE
BLACK
BLACK
WHITE
WHITE
RED
BLUE
BLACK
BLUE
WHITE
HANGER BALL
emersonfans.com
U.L. Model No.: CF880
WHITE
Advertisement
Table of Contents
