Table of Contents
Advertisement
TRENDnet User's Guide
Configuration
After completing the AutoRun Wizard, you are ready to use your camera. The
camera's built-in Web configuration utility is designed to allow you to easily access and
configure your camera. Open a web browser such as Internet Explorer® and enter the IP
address of your camera (Default IP Address: http://192.168.10.30).
Note: By default, this camera obtains an IP address from a DHCP server on the local
network. To find the IP address of the camera, consult the DHCP client list on the DHCP
server. However, if there is no DHCP server available, the static default IP address of this
camera is 192.168.10.30.
These initial steps are using Internet Explorer.
To log in, type the Username admin and the password you created in the Setup Wizard.
If you did not create a password, the default password is admin. After entering your
password, click OK.
© Copyright 2013 TRENDnet. All Rights Reserved.
After you have logged in, Internet Explorer will prompt you to install the camera add-on
required. Click Allow to install the add-on.
TV-IP562WI
23
Advertisement
Table of Contents
