Page 1
PROFESSIONAL AUDIO SYSTEM SP425A OPERATING MANUAL Ver. SP425A-EN-1.1 LSS Advanced Speaker Systems Via On. Longo 53-89024 Polistena (RC) ITALY Tel (39) 966 9321299 – Fax (39) 966 933007 Email: info@lss.it - Internet: www.lss.it...
Page 2
Every precaution has been taken in the preparation of this manual. Nevertheless, LSS assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained in this publication.
LSS produces professional audio products – the result of exceptional engineering and meticulous craftsmanship. This manual is intended for use with LSS loudspeaker. This includes: safety precautions; installation, set-up and operating instruction. Please read this manual plus any accompanying manual and follow all relevant precautions and instructions.
LSS loudspeakers can produce sound levels capable of causing permanent hearing damage from prolonged exposure. The higher the sound level, the less exposure needed to cause such damage CAUTION: This product is energized as long as it is connected to the AC.
SP425A________________________________________________________________________________ APPLICATION LSS's SP425A is a 2-way loudspeaker system that provides high output, low distortion sound reinforcement for the entire range of pro audio applications. The 250 mm (10") low frequency cone and 44 mm (1.75") voice coil high frequency compression driver provides higher output and lower distortion plus enhanced power handling capabilities for better performance in both portable and permanently installed applications.
SP425A________________________________________________________________________________ INSTALLATION AND WIRING SP425A speaker can be mounted to the wall, on a pole or suspended through the suspension points. For installation on a pole, use the pole mount plate in the bottom of the case, speaker can be mounted on a tripod or on another speaker (sub).
Page 9
You can now use the system. If necessary, adjust the volume by adjusting the potentiometer. If you want to change the preset, follow the instruction below. Operating Manual ver. SP425A-EN-1.1 |9...
Page 10
P2 – preset 2 (green): indicates the factory presets VOCAL. P3 – preset 3 (green): indicates the factory presets LOUD. P4 – preset 4 (green): indicates the factory presets FLAT. Presets Status XLR IN XLR OUT AC Input ON/OFF VDE Connector Button 10| Operating Manual ver. SP425A-EN-1.1...
Warning: If the product is used for business purposes, the following steps to delete it: contact your LSS dealer for information about the product recall. Might be charged for the costs of collection and recycling. Small products (and amounts) might be taken back by your local collection facilities.
Poor system hissing, grounding or ground Check and correct the system grounding, as required. humming loop If these suggestions do not solve your problem, contact your nearest LSS dealer or LSS distributor. 12| Operating Manual ver. SP425A-EN-1.1...
Need help?
Do you have a question about the SP425A and is the answer not in the manual?
Questions and answers