OLIMEX LPC11C24 User Manual page 12

Cortex-m0 development board

Table of Contents

Distributor of Olimex LTD: Excellent Integrated System Limited

Datasheet of LPC-P11C24 - DEV BOARD FOR LPC11C24 CORTEX M0

✔ 12 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used as a

system clock.

✔ Crystal oscillator with an operating range of 1 MHz to 25 MHz.

✔ Programmable watchdog oscillator with a frequency range of 7.8 kHz to 1.8 MHz.

✔ PLL allows CPU operation up to the maximum CPU rate without the need for a high-

frequency crystal. May be run from the system oscillator or the internal RC oscillator.

✔ Clock output function with divider that can reflect the system oscillator, IRC, CPU

clock, or the Watchdog clock.

 Power control:

✔ Integrated PMU (Power Management Unit) to minimize power consumption during Sleep,

Deep-sleep, and Deep power-down modes.

✔ Three reduced power modes: Sleep, Deep-sleep, and Deep power-down.

✔ Processor wake-up from Deep-sleep mode via a dedicated start logic using 13 of the GPIO

pins.

✔ Power-On Reset (POR).

✔ Brownout detect with four separate thresholds for interrupt and forced reset.

 Unique device serial number for identification.

 Single 3.3 V power supply (1.8 V to 3.6 V).

 Available as 48-pin LQFP package.

For comprehensive information on the microcontroller visit the Freescale's web page for a

datasheet.

At the moment of writing the microcontroller datasheet can be found at the following link:

http://www.nxp.com/documents/data_sheet/LPC11CX2_CX4.pdf

Page 11 of 26

LPC-P11C24 user's manual

Table of Contents