Diagnostics - Dell Inspiron 13 7000 Service Manual

Hide thumbs Also See for Inspiron 13 7000:
Table of Contents

Advertisement

3. In the boot menu screen, use Up/Down arrow key to select the Diagnostics option and then press Enter.
NOTE:
The Enhanced Pre-boot System Assessment window displays, listing all devices detected in the computer.
The diagnostics starts running the tests on all the detected devices.
4. Press the arrow in the lower-right corner to go to the page listing.
The detected items are listed and tested.
5. To run a diagnostic test on a specific device, press Esc and click Yes to stop the diagnostic test.
6. Select the device from the left pane and click Run Tests.
7. If there are any issues, error codes are displayed.
Note the error code and contact Dell.

Diagnostics

Power and battery-status light/ hard-drive activity light: Indicates the battery-charge status or the hard-drive activity.
NOTE:
Press Fn+H to toggle this light between power and battery-status light and hard-drive activity light.
Hard-drive activity light
Turns on when the computer reads from or writes to the hard drive.
Power and battery-status light
Indicates the power and battery-charge status.
Solid white – Power adapter is connected and the battery has more than 5 percent charge.
Amber – Computer is running on battery and the battery has less than 5 percent charge.
Off
● Power adapter is connected and the battery is fully charged.
● Computer is running on battery and the battery has more than 5 percent charge.
● Computer is in sleep state, hibernation, or turned off.
For example, the power and battery-status light blinks amber two times followed by a pause, and then blinks white three times
followed by a pause. This 2,3 pattern continues until the computer is turned off indicating no memory or RAM is detected.
The following table shows different light patterns and what they indicate.
Table 18. Diagnostics
Light pattern
2,1
2,2
2,3
2,4
2,5
2,6
2,7
3,1
3,2
3,3
3,4
Camera status light: Indicates whether the camera is in use.
● Solid white – Camera is in use.
● Off – Camera is not in use.
Problem description
CPU failure
System board: BIOS and ROM failure
No memory or RAM detected
Memory or RAM failure
Invalid memory installed
System board or chipset error
LCD failure
CMOS battery failure
PCI/video card failure
Recovery image not found
Recovery image found but invalid
Troubleshooting
79

Advertisement

Table of Contents
loading

Table of Contents