Chapter 19: Removing The Display Assembly; Prerequisites; Procedure - Dell Inspiron 13 7000 Service Manual

Hide thumbs Also See for Inspiron 13 7000:

Table of Contents

NOTE:

Before working inside your computer, read the safety information that shipped with your computer and follow

the steps in

Before working inside your

working inside your

computer. For more safety best practices, see the Regulatory Compliance home page at

regulatory_compliance.

Topics:

•

•

Prerequisites

1. Remove the

base

cover.

2. Follow the procedure from step 1 to step 4 in

Procedure

NOTE:

The touchscreen-board cable removal is only applicable for computers shipped with touchscreen configuration.

1. Remove the antenna cables from the routing guides on the palm-rest assembly.

2. Peel off the adhesive tapes that secure the display cable and touchscreen-board cable to the system board.

3. Open the latch and disconnect the display cable from the system board.

4. Open the latch and disconnect the touchscreen-board cable from the system board.

5. Turn the computer over and open the display as far as possible. Then place the computer face down on a flat surface.

CAUTION:

Place the computer on a soft and clean surface to avoid scratching the display.

6. Remove the six screws (M2.5x5) that secure the display assembly to the palm-rest assembly.

7. Gently lift the display assembly off the palm-rest assembly.

Removing the display assembly

computer. After working inside your computer, follow the instructions in

Removing the wireless

card.

After

www.dell.com/

Table of Contents