!
CAUTION
Lutron recommends that Keypads be installed by a qualified electrician.
Do not connect high-voltage power to low-voltage terminals. Improper wiring can result in personal injury or damage to
the control or to other equipment.
Keypads must be connected to the Sivoia QED
National Electrical Code
allowed in your area.
Use only a cloth with warm water and mild soap to clean faceplates (no chemical cleaners).
Keypad Configurations
Non-insert version shown. Insert version also available.
SVQ-2W, SVQ-2WRL
Status
Indicator
LEDs
SVQ-3W, SVQ-3WRL
*
Infrared Receiver available on SVQ-4WRL-IR only.
** Raise and Lower buttons only available on SVQ-2WRL, SVQ-3WRL, SVQ-4WRL-IR, and SVQ-5WRL only.
Installation Instructions
Electronic Drive Unit (EDU) by using Class 2/PELV wiring methods per the
™
. Check with your local electrical inspector for the local code requirements and wiring practices
®
SVQ-2WD
Open button
Close button
Raise/Lower**
SVQ-3WD
Open button
Preset button
Close button
Raise/Lower**
Open button
Close button
Open button
Close button
Open button
Preset button
Close button
Open button
Preset button
Close button
2
SVQ-4WRL-IR
Open button
Preset 1 button
Preset 2 button
Close button
Infrared Receiver*
Raise/Lower**
SVQ-5WRL
Open button
Preset 1 button
Preset 2 button
Preset 3 button
Close button
Raise/Lower**
Occupant Copy