Keypad Configurations - Lutron Electronics SQE-2 Manual

Please read before installing.
!
CAUTION
Lutron recommends that Keypads be installed by a qualified electrician.
Do not connect high-voltage power to low-voltage terminals. Improper wiring can result in personal injury or damage to
the control or to other equipment.
Keypads must be connected to the Sivoia QED
methods.
Check with your local electrical inspector for the local code requirements and wiring practices
allowed in your area.
Use only a cloth with warm water and mild soap to clean faceplates (no chemical cleaners).

Keypad Configurations

SQE-2
Status Indicator
LEDs
Open button
Close button
SQE-3D
Status Indicator
LEDs
Open button
Preset button
Close button
Installation Instructions
Electronic Drive Unit (EDU) by using
TM
SQE-RL
Status Indicator
LEDs
Raise button
Lower button
2
Class 2 (USA)/ PELV(IEC) wiring
SQE-3E
SQE-33
Group Selection
LEDs
Group 1 button
1
Group 2 button
2
Group 3 button
3
Status Indicator
LEDs
Open button
Preset button
Close button
Infrared
Receiver
Raise/Lower
Status Indicator
LEDs
Open button
Preset button
Close button
Raise/Lower
Occupant Copy