Model C723 Specifications - Taylor C723 Service Manual

Model C723 Specifications

Freezing Cylinder
Two, 2.8 quart (2.7 liter)
Mix Hopper
Two, 14 quart (13.2 liter)
Beater Motor
Two, 1.0 HP
Refrigeration Unit
One, 9,500 BTU/hr. R404A
Separate Hopper Refrigeration (SHR)
One, 400 BTU/hr. R134a
(BTU's may vary, depending on compressor used)
Electrical
One dedicated electrical connection is required. See
the electrical chart for the proper electrical
requirements. The C723 is manufactured to be
permanently connected. Consult your local Taylor
Distributor for cord and receptacle specifications as
local codes allow.
Maximum
Electrical Fuse Size
208-230/60/1 Air 40
208-230/60/1 40
Water
208-230/60/3 Air 25
208-230/60/3 25
Water
220-240/50/1 Air 30
380-415/50/3N~ 12
Air
This unit may be manufactured in other electrical
characteristics. Refer to the local Taylor Distributor
for availability. (For exact electrical information,
always refer to the data label of the unit.)
130815
Introduction
Minimum Poles (P)
Circuit Wires (W)
Ampacity
29 2P 3W
29 2P 3W
18 3P 4W
18 3P 4W
24 2P 3W
9 4P 5W
4
Air Cooled
The Model C723 air cooled unit requires a minimum
of 6" (152 mm) on the left and right sides and 0" on
the back.
The Model C723 unit equipped with top air discharge
chute directs heated air exhaust upward. The
minimum clearance above the top air discharge
chute is 12" (305 mm), 6"" (152 mm) on the left side,
0" on the right side, and 0" on the back.
Water Cooled
The water inlet and drain connections are located in
the rear panel (3/8" FTP / 9.5 mm).
Dimensions
Width: 23-5/16" (592 mm)
Depth: 33-13/16 (858 mm)
Height: 36-1/2" (927 mm)
Counter Clearance*: - - -
*Designed to rest on a plastic pad directly on
counter top or optional cart.
Approximate Weights
Net: 500 lbs. (227 kgs)
Crated: 559 lbs. (254 kgs)
Volume: 39.2 cu. ft. (1.11 cu. m.)
Optional Carts
There are two optional carts available.
1. C20600-AFB: ADA compliant height cart,
not equipped with a door.
2. C20600-000: Standard height cart with
reversible front door panel and rear panel.
Note: If the door is required on the rear of the
cart instead of the front, the front door panel
and the rear panel can be reversed. To reverse
these panels, remove the five screws on each
panel. Reverse and reinstall the panels, making
sure all screws are reinstalled.
IMPORTANT! For safety purposes, the
freezer must be bolted to the cart using all 4
bolts. Failure to comply could result in personnel
injury and equipment damage.
Model C723